Open my 3D printing store!

Hello everyone! I am Jordan, and I have been 3d printing for 5 years. It started as a hobby, and quickly became a side hustle. And over the years, it has basically become my full time job.

As some of you know, I am trying to open my 3D Printing store.

1. I have to obtained my LLC!

2. I have found insurance.

3. I have secured a location in the gulf view square mall in Port Richey, Fl. Well, I have a lease drawn up for me to sign. So I was approved for the location.

I’m short a bit to sign the lease, but I am so close!

must sign by the 16th.

4. I have my EIN.

I still need to do the following:

1. Redo the floors and paint. $500-$1000

2. Inspections (are being done on 10-10-23)

3. Fix a spot on the wall(drywall repair) $150

4. Sign the lease!(short $300)

5. Buy POS hardware(register and card reader)$1000

6. Some state fees ($300-$400)

7. Shelves, display stands, and a register table/counter. (A place for the POS system)

I was very reluctant to make this post, as I am a little embarrassed to have to resort to this, but ai also know this might be the only option left.

I’m asking for any help from anyone and everyone to donate what you can to help me open my new store.

Because of lack of credit history(not bad credit) the small loans I applied for, have been denied. I know money is tight for some, but I am seeking the help of anyone who is able!

The funds I raise here, are to help fund the repairs, get new shelving units, and pay any other smaller fees that seem to keep coming in the mail and everything else that will help me get my store off of the ground!

I have set a goal of $2,000, but will forever be grateful to reach any goal to open my doors!

Thank you all very much for helping me achieve my dream!